What Are Starter Shingles?
Starter shingles are the first row of shingles installed along the edges of an asphalt roof, underneath the first visible course. They seal the bottom edge of that first course so wind can’t lift it, and they cover the gaps between the shingles above so rain can’t run straight onto the roof deck. Most roofers use factory-made starter strip shingles because the sealant sits exactly where it needs to be.
You can’t see starter shingles from the ground, which is why a missing starter strip can go unnoticed for years, until the roof edge starts leaking or the first row of shingles blows off in a storm.
Do You Need Starter Shingles on a New Roof?
Yes. On an asphalt shingle roof, a starter course is a standard part of a correct installation, not an upgrade. Shingle manufacturers include it in their installation instructions, and roofers who skip it are cutting a corner you will pay for later.
In western Pennsylvania, eastern Ohio, and West Virginia, the roof edge takes the worst of the weather. Wind-driven rain, freeze-thaw cycles, and ice dams all attack the eaves first. A properly sealed starter course is the roof’s first line of defense right where that damage starts.
What Happens When a Roofer Skips the Starter Strip?
A roof without a starter strip can look fine for a long time. The damage builds slowly at the edges:
- Water gets through the first row. Shingles have gaps between pieces and cutouts between tabs. Without starter shingles underneath, rain runs through those openings onto the deck at the eave.
- The first row lifts in high wind. The starter strip’s sealant is what bonds the bottom of the first course. Without it, wind can get under the edge and peel shingles back.
- The edge rots first. Repeated wetting at the eave softens the deck edge and the fascia board behind the gutter.
- Warranty coverage can be at risk. Manufacturer warranties, especially for wind, depend on the shingles being installed according to the instructions, and those instructions include a starter course.
How Are Starter Strip Shingles Installed?
Every manufacturer has its own details, and their instructions always come first. On a typical asphalt roof, starter strip shingles installation follows this order:
- Prep the roof edge. Install the drip edge and underlayment first, including an ice-and-water barrier along the eaves in our climate.
- Set the starter along the eaves. The strip runs the full length of the eave, with its sealant line at the lower edge where it bonds to the first course.
- Get the overhang right. The starter hangs slightly past the drip edge, often about 1/4 to 3/4 inch per the manufacturer, so water drips into the gutter instead of behind it.
- Offset the seams. Starter pieces are cut so their joints don’t line up with the joints of the first course above.
- Nail to the pattern. Nails go where the manufacturer specifies, in the area the first course will cover, never through the sealant strip.
- Add rake starter where specified. Many systems also call for starter along the rake edges to lock down the shingle ends against wind.
- Install the first course. The first full row goes right over the starter, and the sealant bonds the two once the sun warms the roof.
For the next steps of a proper install, see our guides on how many nails go in each shingle and how to stagger architectural shingles.
Keep Reading
Choose a topic below to jump to another post.
Can You Use Regular Shingles as a Starter Strip?
Sometimes, but it is easy to get wrong. With three-tab shingles, an installer can cut off the tabs and set the remaining strip with the sealant at the eave edge. What doesn’t work is flipping a regular shingle upside down, because that puts the sealant at the wrong edge and the first course never bonds properly. Architectural shingles can’t simply be cut down into starters, because their layered design doesn’t leave a flat, sealed edge. That is why most crews, ours included, use a dedicated starter product.
How Can You Tell If Your Roof Is Missing a Starter Strip?
Stay off the roof. From the ground and from inside your home, watch for these signs:
- Shingles along the bottom edge lifting, curling, or missing after a windstorm
- Water stains on ceilings or walls near the exterior walls of the house
- Soft, stained, or rotting fascia boards behind the gutters
- Gaps or daylight visible under the first row of shingles through binoculars
Any of these is worth a closer look. In many cases, a missing starter strip can be fixed along the eaves without replacing the whole roof, as long as the decking underneath is still sound. If a leak has already started, here is how long a roof repair usually takes.
Why the Roof Edge Is Where Good Workmanship Shows
A roof is only as strong as its edges. Our crews bring an Amish craftsmanship approach to the details most homeowners never see, from the starter course to the nailing pattern, and we install Atlas shingles to the manufacturer’s specifications. Depending on the situation and the service we provide our $30,000 workmanship guarantee.
Worried about the edges of your roof? We inspect roofs across western Pennsylvania, eastern Ohio and northern West Virginia and will show you exactly what we find.
FAQ'S
Nail them where the shingle manufacturer specifies, in the area the first course of shingles will cover. Nails should never go through the sealant strip, and they shouldn’t be left exposed at the roof edge.
Many shingle systems call for starters along the rake edges as well as the eaves, because it helps seal the ends of each course against wind. Follow the instructions for the specific shingle on your roof.
They should come from the same manufacturer as your shingles, because the shingle warranty is written around that manufacturer’s system. The color matters less, since the starter course is almost completely hidden once the first row is installed.
It depends on the manufacturer and the warranty. Most installation instructions include a starter course, and a roof that wasn’t installed to those instructions may not qualify for some coverage, especially for wind damage.
DO YOU NEED SOME HELP?
Call us now or schedule a service
Available for inspections, emergency repairs & more.



